Booth Brainstorming

Counter - measure depths of Express+monitor, mixer, and typical rack case - counter should be the depth of the greatest of these three. OR - since I know that the mixer is going to be the deepest object by a lot, make the counter in the sound half of the booth that much deeper, and leave the other side just deep enough to accomodate the express+monitor.

Electrical stuff - outlets, and lots of 'em. Two 20-amp circuits per half of the booth, And another circuit, separate from those, for overhead lighting. Fluorescent lights are fine for general use, but a dimmable system for performances will be needed as well. Receptacles should be located along the length of the counters on approximately 4' centers, below counter level. Cords from equipment on the counters can be routed through holes in the counters, similar to how a typical office desk is set up. Additional outlets should be located along the back and side walls.

We're also going to want ethernet receptacles. 2 ports on each half of the room will be fine.

Clear-Com - jacks, flush-mounted to the wall if possible, just above counter level. Two-channel boxes, one located at either end of each counter, and one in the center of each counter (if window allows).

Telephone, on the back wall somewhere, capable of a silent or 'do not disturb' mode.




Storage - move existing metal shelving units and cabinets from Lido




Things to store in the booth:



Ancillary expenses: